Chemical control knob not open far enough or too far open.Doesn’t a raw chemical/detergent like it should Verify that Inlet adapter is attached to machine’s water inlet and that the quick connect coupler is attached to garden hose.Ĭraftsman 919.16225 pressure washer troubleshooting Edit PROBLEMġ. Quick connect assembly is attached in reverse. ( ensure when you turn on the unit, trigger gun is at “on” position). Switch off pressure washer, squeeze trigger gun waiting for a steady flow of water emerge from spray nozzle, then turn on the unit. Unit might hum.ĭisconnect water supply and power ON for 2 to 3 seconds, repeat couple times or until the motor starts. Pressure washer not used for long periods. Unplug any extension cords attached and plug the unit directly into the outlet. Turn unit “OFF”, squeeze trigger on spray wand to release pressure, then turn unit “ON”. Verify that only the pressure washer is running on this circuit. Water leaks from pump (up to 10 drops per minute is permissible). Remove water filter and rinse in warm water. Turn off machine and purge pump by squeezing trigger gun until a steady flow of water emerges through the nozzle. Turn nozzle tip to low-pressure position.īlow out or remove debris with a fine needle.Ĭheck that hoses and fittings are airtight. Remove obstruction or replace detergent suction tube. Run warm water through filter to remove build-up.ĭamaged or clogged deter- gent suction tube. Check garden hose for kinks, leaks or blockageĭetergent bottle or suction tube not properly connected.įilter on detergent suction tube is clogged. Turn “OFF” machine, and purge pump by squeezing trigger gun until a steady flow of water emerges through the nozzle. Turn power nozzle to high- pressure position.Ĭheck that hoses and fittings are airtight. Power nozzle is in low- pressure position. ![]() ![]() Replace with a 1” (25 mm) or 5/8” (16 mm) garden hose.Ĭheck garden hose for kinks, leaks and blockage. Tripped pressure washer temperature breaker Drain fuel tank fill with fresh fuel.Ĭraftsman 138.75275 pressure washer troubleshooting Edit PROBLEMĮlectrical outlet does not sup- ply adequate power. Spark plug wire not connected to spark plug.ħ. If engine still “bogs down”, contact local service facility.Įngine will not start or starts and runs rough.Ĥ. Rotate detergent shut-off valve to “On” position.Įngine runs good at no-load but “bogs” when load is added. Detergent shut-off valve is in “Off” position.ġ. High pressure hose is blocked or leaks.ġ. Pump has following problems: failure to produce pressure, erratic pressure, chattering, loss of pressure, low water volume.ħ. – Flow regulation control is set to low pressureĬheck to see that water supply is on full force or use stationary water source.Īdjust detergent metering valve to desired setting.Ĭlean filter in suction nozzle Clean nozzleĬraftsman 580.7523 pressure washer troubleshooting Edit Problem Stop engine, press trigger of gun, start engine and run unit while depressing trigger Craftsman 1750 pressure washer troubleshooting Edit Faultĭrain tank and refil tank with fresh, clean fuelĬonnect spark plug wire Replace spark plug
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |